Cost-effective, computer-controlled, full-featured debugging and verification tests for LoRaWAN® technology gateways and devices
The RWC5020M offers comprehensive test and diagnostic capabilities for LoRaWAN® gateways and devices. In conjunction with a controlling PC, it can be used in engineering to test all aspects of the LoRaWAN protocol implementation in a device or gateway, as well as testing RF performance, and it can run full device pre-certification tests for a variety of regions. It can can drive automatic regression testing for CI testing and hardware design verification.
How it works
The RWC5020B has a sophisticated programmable RF front end, that can operate over a wide range of frequencies, from 400 MHz to 510 MHz, or 862 MHz to 928 MHz (selected at time of purchase). It can operate in a several modes.
- It can simulate a gateway and the required portions of the LoRaWAN network. This means that devices under test can join the RWC5020M’s built-in network as if they were joining the real network; and the RWC5020M can simulate networks that are not otherwise available in your engineering lab.
- It can simulate a device in order to exercise a gateway.
- It can operate at the physical layer (“non-signaling” mode) to generate tests patterns and measure RF performance of the equipment under test. This is useful for both engineering and mass production testing.
- It can run test procedures that closely track the LoRa Alliance test procedures used by test labs for certification.
While performing testing, the RWC5020M can vary the RF parameters, to ensure that the target equipment is tested in a variety of situations.
Supported Device Classes and LoRaWAN releases
The RWC5020M supports testing LoRaWAN Class A, Class B, and Class C operation, and supports LoRaWAN 1.0.2, 1.0.3, and 1.1 protocols.
A very important use case of the RWC5020M is preparing for LoRaWAN certification at a test lab. The RWC5020B has comprehensive pre-compliance test procedures that are available for the following regions.
- EU 863-870 MHz (requirement spec V1.5)
- US 902-928 MHz (requirement spec V1.3)
- Asia AS 923 MHz (requirement spec V1.1)
- South Korea 920-923 MHz (requirement spec V1.2)
- India 865 MHz (requirement spec V1.1)
All operation of the RWC5020M can be controlled by a remote PC, using either Ethernet or RS232 control. A Python test library is available from MCCI to simplify test development. The library has been tested both on PCs and on Raspberry Pi 2 Linux systems, allowing for cost-effective deployment in a lab environment.
Other Family Members
The RWC5020M is the computer-controlled version of the RWC5020B stand-alone tester. It has the same RF and test capabilities as the RWC5020B, but lacks the front panel control, and requires that you connect it to a separate test computer (not included).
Lots more information is available from RedwoodComm’s site: check the RWC5020B home page; with the exception of the front panel controls, all information about the RWC5020B applies equally to the RWC5020M.
Why buy from MCCI?
For over 25 years, MCCI has been offering tools and software to engineers around the world. We’ve been doing LoRaWAN since 2016, and we are very actively involved in LoRaWAN deployments in New York City, Ithaca, NY, and in India. Our engineers have a deep practical understanding of LoRaWAN and the importance of good test equipment when solving real-world problems. We can arrange a demo via the web, or hands-on in person.
For over twenty years we've been developing and licensing USB system software to be embedded into our customers’ consumer-electronics products.